Air-cooled Chiller
Industrial chillers are used for controlled cooling of products, mechanisms and factory machinery in a wide range of industries, including plastic injection and blow molding industry. The industrial chillers assist to improve the production efficiency and minimize the rejection ratio of finished products. A chiller will use either a vapor compression or absorption cycle to cool.
Chillers can be either air-cooled or water-cooled.
Air-cooled chiller requires less maintenance than water-cooled unit and it dispenses with the need for cooling towers. However, the air-cooled chiller generally consumes approximately 10% more power than a water-cooled unit. It transfers the heat absorbed to surrounding air directly.
Water-cooled chiller absorbs heat from process water and transfers it to a separate water source such as a cooling tower, river or pond. A cooling tower is a must if there is no direct discharge source like river or pond. The water could be reused after special treatment to remove the dusts and impurities.
There are SWC series water-cooled chillers and SAC1series air-cooled chiller for you choosing. Please kindly contact us for you detail request.
Features:
1.cooling temperature range 5-35 centigrade temperature.
2. High-capacity tube-in-shell evaporator with very good heat exchange performance especially under high ambient temperature condition. The heat exchange power is: 15KW
3.Tube-fin double condensers with excellent heat transfer and rapid cooling. The efficiency of condensers is 17.5KW
4. Stainless steel warm-keeping water tank.
5. Overload protection for compressor, pump and blower.
6. Warm-keeping design for all piping to avoid partial convection.
7. Independent temperature controller, anti-freeze protection.
8. Phase sequence protection for control circuit, refrigeration loop controlled by high and low pressure switch.
9. R22 refrigerant to be used for efficient cooling.